Skip to content

Internal Object Store

Before you start

Goal

  • Setup the Altair SLC Hub to use the internal object store.

Prerequisites

  • Administration privileges for the host.

Configuring the internal object store connection

External Object Store

  • If intending to use an external object store, see here.

Altair SLC Hub will install an object store out the box for easy use.

The connection to the object is configured using the object_store configuration section. A list of the configuration settings and comments on their use is found in the hub configuration file [etc directory]/config.d/object_store.yaml.

By default, the Altair SLC Hub will attempt to detect legacy configuration in an s3 section. If no s3 section exists, it will default to the internal object store. To make sure Altair SLC Hub is using the internal object store, create a configuration file with a lexicographically greater name, such as object_store_internal.yaml. Set the contents of the file to:

object_store:
  type: internal

Start the object store

Now start the object store service with the following command:

hubctl service start objstore

Check that the service has started successfully:

hubctl service status objstore

Verification

Verify object store

  • run the hubctl verify objectstore command

Before continuing, it is necessary to verify that the connection information for the object store is correct. To do this, use the following hubctl command:

hubctl verify objectstore